|
|
Servicing
Toyota MR2 Other - replace air filter in 2003 Toyota MR2 Spyder
submitted by SpyderGirl on 16/08/2008 | | I must be riding the same stupid bus as the other person, because I cannot locate the air filter on my 2003 Spyder to change the filter. The internet has not been helpful and I do not yet have an owners manual. Help us! |
Toyota MR2 MK2 N/A - Air filter
submitted by Will on 12/11/2006 | | Where can i buy a decent air filter from? | | Fix / Recommendation 1 submitted by Dean Hitchens on 11/03/2009 | Hi, ive tried two different types on my rev3 N/A. The HKS Green super megga flow and the K&N variety. The HKS was the easiest to keep clean just unscr.... More |
Toyota MR2 MK2 N/A - Import with No Manual
submitted by Jon Mallory on 17/01/2005 | | Just bought K reg G-limited import MR2 Mk2, does anyone know how much oil it will take as about to carry out an oil change...?
Thanks, if poss could you reply by email as unable to check this site from owrk very often. | | Fix / Recommendation 1 submitted by David Attard on 04/11/2007 | | exactly 4.6 litres.... More |
Toyota MR2 Other - replacing the air filter on a 2003
submitted by Frank Foster on 31/10/2004 | | Ok maybe I am just plain stupid but I cannot seem to figure out how to change the air filter on my 2003. Does anyone know a solution to my problem? I would appreciate any assistance. |
Toyota MR2 MK2 N/A - need an owners manual
submitted by Kelly Eratt on 09/10/2004 | | Hi there please can anyone help, I need a workshop manual or original handbook. Bought one and it's a japanse fron car imported books/ car handbooks a translated one. With cartoon pictures and no useful info at all | | Fix / Recommendation 1 submitted by Joe on 11/07/2007 | | visit http://teq.org/mr2manual/
or click "MR2 Manual" on the right of this page
and youll be able to download the relevant manual(s).
.... More | | Fix / Recommendation 2 submitted by scott on 23/10/2005 | | Hi there can anyone help, i require a workshop manual or handbook. i have just recently bought the toyota mr2 mark 2 (1992) from my local gargae. Than.... More | | Fix / Recommendation 3 submitted by grant webb on 05/05/2005 | | Hi, I have two different manuals on CD, one is all the pages from both of the official manuals and the other is exploded schematics etc. E-mail me and.... More |
Toyota MR2 MK2 N/A - how much anti-freeze?
submitted by Kelly Eratt on 09/10/2004 | | Can anyone tell me how much anti-freeze to put or how much water it holds/capacity of the radiator in as I want to change the coolant before cold weather. | | Fix / Recommendation 1 submitted by terry on 12/10/2004 | | 6.8litres anti-freeze 50% ditilled water.... More |
Toyota MR2 MK2 N/A - rattling noise at certain revs
submitted by theo on 17/03/2004 | | Hey, i am responding to the guy who had this rattling noise emanating from the engine compartment.
It took me 2 years to figure this out, but on my '91 NA i eventually found out it was the left (from behind) engine mounting that needed realignment. To realign is a different matter altogether but take it out, stand the motor on soemthing and viola! your noise is gone. | | Fix / Recommendation 1 submitted by mike ireland on 19/04/2005 | | i had same problem at 1800rpm a rattle i found this to be the cam tensioner i replaced it with the belts and it stoped oh this was on a 93 turbo my pr.... More |
Toyota MR2 MK2 N/A - rattling noises
submitted by maxine on 15/03/2004 | | when revving my mr2 mk2 non turbo 93 to about 2000 revs i get a sort of rattling/farting noise from the engine compartment it does this through every gear but only at this rev range before 2000 its fine and after its fine and the car dosent have to be moving either prior to this i had the clutch changed because it was slipping oh and also some of the dash lights come on now and again battery,caution,and engine overheating and i think water but ive just had it serviced and they said it was ok if anyone has any idea could you please help...thanks | | Fix / Recommendation 1 submitted by sims on 02/08/2008 | | yea man its definatly of the heat shields. i have a 91 mr2 and it did the same thing. either tighten the screws or weld it down if that doesnt work.... More | | Fix / Recommendation 2 submitted by michael ireland on 19/04/2005 | | make sure they bled your coolant proply this will couse over heating.... More | | Fix / Recommendation 3 submitted by michael ireland on 19/04/2005 | | hi i had same problem a rattle woteva the gear at 1800 revs i found this to be the cam tensioner i changed it wen i changed the belts i also changed t.... More | | Fix / Recommendation 4 submitted by Mark Wilson on 11/01/2005 | | My 1991 import does the same at 2100-2200 revs. Apparently it is a heat shield which is loose. Need to get under car, find the loose one and tighten i.... More |
Toyota MR2 MK1 N/A - Failed Emission Test
submitted by DagW00d on 14/03/2004 | | My 89 MR2 failed the Hydrocarbons portion of the emission test. It's supposed to be under 0.80 (Composite), but it reads 2.22CO is OK @ 8.8, CO-2 is good @ 304.8. it's a standard 4AGE engine , I'm not certain if the previous owner didn't tweek it some. It has a modified air filter assembly. I have the original could that cause any problem. Is there a way to modify the brain or sensors to fake it temporarily, or is it a sensor bad oxy egr etc. THANX | | Fix / Recommendation 1 submitted by Daf on 13/12/2009 | | Is there an Exhaust leek? Blowing? It would fail the emision test if it was blowing..... More | | Fix / Recommendation 2 submitted by Cougar303 on 25/08/2009 | | I had the same problem failed MOT due to emissions which was fixed with a new Lambda sensor ! hope this helps.... More | | Fix / Recommendation 3 submitted by rob on 23/03/2004 | | unfortunatly when you fail because of excesive hydrocarbons ANYTHING could be wrong with your engine. I would start by going threw a normal tune up. .... More |
Toyota MR2 MK2 Turbo - ABS Service Light
submitted by Angela Wilson on 06/03/2004 | | My ABS Service Warning light remains on constantly despite it being looked at by two seperate garages. My ABS are ok and they suggested it could be a faulty sensor but again can't tell me which one is faulty, they can't switch the light off. Can anyone suggest how to turn it off? | | Fix / Recommendation 1 submitted by Charles on 23/03/2005 | | You need to examine the codes stored in the ABS ECU which tells you what the problem is. Can be done manually but best left to a grage with the correc.... More |
Toyota MR2 MK2 N/A - Technical Schematics - (90-91H reg) MR2 MkII N/A 3SGE
submitted by Marky mark on 28/07/2003 | | Can anyone point me towards any technical drawings schematics for the following, (90-91H reg) MR2 MkII N/A 3S-GE. Everything online appears to be for the Turbo version,ie. 3S-GTE engine configuration. Arrrgghhh! | | Fix / Recommendation 1 submitted by Chunks on 29/07/2003 | | What are you looking for specifically?
.... More |
Toyota MR2 MK2 Turbo - HAND BREAK CABLE
submitted by PAUL HARRIS on 09/07/2003 | | HOW DO U ADJUST THE HAND BREAK CABLE? | | Fix / Recommendation 1 submitted by g saunders on 06/05/2010 | | how do i fix/tighten hand break cable.... More | | Fix / Recommendation 2 submitted by Mike on 12/07/2003 | | You remove the plastic covers on the bottom of the car and the adjusters will be exposed.
However, its very liekly that they dont need adjusting un.... More |
Toyota MR2 MK2 Turbo - Jacking points
submitted by Martyn thompson on 23/06/2003 | | does anyone know the correct jacking points on an mr2 | | Fix / Recommendation 1 submitted by Mike on 12/07/2003 | | If you want to use a trolley jack then jack the car up at the back using the rear crossmember rather than the sill jacking points..... More | | Fix / Recommendation 2 submitted by Chunks on 25/06/2003 | | Just behind the front wheels and just in front of the rear wheele on the sills, there a 2 little cutouts..... More |
Toyota MR2 MK2 Turbo - Clutch has gone?
submitted by PAUL HARRIS on 20/06/2003 | | MY CLUTCH HAS GONE COMPLETELY IS THIS A BIG JOB TO DO MYSELF? | | Fix / Recommendation 1 submitted by liam on 23/12/2003 | | You will not be able to do this yourself without a ramp/tools. I work as a technician myself and it took me 7 hours to change my clutch at work in my.... More | | Fix / Recommendation 2 submitted by Mike on 12/07/2003 | | Big job. The transmission is very heavy and access is very tight. This isnt the sort of job youd want to do on your driveway. If you have a decentl.... More |
|
|
|